BMW K1600 Forum banner

Cylinder Logo

3K views 9 replies 7 participants last post by  wemi 
#1 ·
I added a nice touch to make the "6" stand out. Remove the small center plastic piece by gently prying up with a thin screwdriver. BE CAREFUL NOT TO BREAK IT OR LOSE IT. Then remove the small torx screw and the 6 will come off. Paint the 6 with a few coats of chrome or aluminum paint and let dry.
 

Attachments

See less See more
2
#3 ·
I should but my hand's not that steady. That would look nice, though.
 
#4 ·
Or you could just buy the chrome version from BMW. See picture (s). Comes with the black plastic insert and a new screw. Some more pics of front mods. Carbon fender and wind wings, 7Jurock .24 thick Goldwing vent 19" flip dark tint shield. Handlebar pouch...
The devil is in the details...how about the yellow roundel??:smile:
 

Attachments

#5 ·
The =6= looks pretty slick (both versions) but, to be perfectly honest, the yellow roundel doesn't float my boat. I like that you like it, though.



 
#6 ·
The chrome is peeling off the edges of my 6 logo. Contemplating replacement or painting. The yellow rounded really ‘pops’ against the black bike. I prefer BMW’s corporate blue & white, but yours does look sharp.
 
#9 ·
What we need to do is swap the black with the silver - two happy campers!

Cheers,

Derek
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top