[RedCard]

Here are a few images of the installation.

The cuts on the plate to accommodate the wires.

All wrapped up.

And through the hole for the license light that sits behind the plate. On the Bagger.

 

[XtBimmer]

Does it play well with the canbus?
I guess I have to tap into each indicator light?

 

[Gunnert]

+1 @RedCard , did you connect directly to the bike's wiring or via an Isolator? If I had to guess I'd say directly to the wiring; e.g. the amp draw from the LED license plate is very minimal.

Duane

 

[RedCard]

I used an ezCAN circuit configured for the brake light. It will flash and light up on deceleration.

But to your point, there are many ways to configure brakes lights. Direct, or with a Skene controller which also has the flashing and decel options, as well as a Run/Brake/Turn option.

I also have the red and amber version. But I opted to only use the red brake function for now. I may wire the amber turn signals later.