I mistakenly pulled one of the 40 amp fuzes and it killed the date & time display. I'm having a hek of a time figuring out how to reset. If anyone knows, please give up the info. Thks.

 

If you go thru the menus, there is an area for date and time to adjust.

 

If you have a NAV installed, it will update for you once you are out for a bit.

 

Click your menu button on the left handlebar to the last page. It will start with Audio. Rotate the wheel down until Time shows. Push the wheel to the right, adjust as needed. Go back to Date and do the same.

 

Got it. Somehow I kept missing a step. Now i just have to figure out how to get the GPS to display daytime so I can see it. I haven't updated it in quite a while, maybe that has something to do with it.

 

Adjusting the display settings is all in 'Tools', so no updating needed as far as I am aware.

For the screen display you need ......... Tools>Settings>Display then Color Mode & select Auto & the screen should automatically switch between day/night.

For Time .......... Tools>settings>Time then choose which format you want to use. Current Time - select Automatic.

 

I think that recently I have read a post about how to solve this problem. There is in the menu such an option, but it's not always working properly, and sometimes if the media was taken off or replaced it can't reset the option, and you have to make it with a diagnostic device like THINKDIAG UK Advanced Diagnostic Tool. I have recently bought one and it helps me to repair my technical problems in the car and be sure that it's working perfectly, the coolest thing is that I can check all the faults from my phone.

 

Why my bmw 1600 gtl (2014) don't remember the time and date?

 

Zakaj si moj bmw gtl 1600 (2014) ne zapomni datuma in časa, če ga ugasnem in ponovno prižgem?

You might find the answer here.

 

Tudi če spremenim nastavitve datuma in ure v meniju, se nastavitve izbrišejo ob ponovnem zagonu motorja. Čas je nastavljen na 0:00, datum pa na 1.1.2080.

 

Tudi če spremenim nastavitve datuma in ure v meniju, se nastavitve izbrišejo ob ponovnem zagonu motorja. Čas je nastavljen na 0:00, datum pa na 1.1.2080.

 

Even if I change the date and time settings in the menu, the settings are deleted when the engine is restarted. The time is set to 0:00 and the date to 1/1/2080.

 

Why doesn't my bmw gtl 1600 (2014) remember the date and time if I turn it off and on again?

 

Because your battery or battery connections are bad.

 

I thought so myself. So I replaced the battery with a new one. But the problem still persists. Every time the engine is started (as soon as I turn on the ignition without starting the engine), the time and date are reset. Otherwise the motorcycle works normally. It turns on normally, without the voltage falling below 12.8V. When the engine starts, the battery voltage immediately goes to 14V (according to the display of data on the screen).

 

Even the electrical cables connected to the battery look fine.

 

If anyone has any ideas, I kindly ask for your help.